How To Clean Your Tank And Change Your Coil

How To Clean Your Tank And Change Your Coil

How To Clean Your Tank And Change Your Coil

What’s going on guys. It’s Angel from Discount Vape Pen. Today I’m gonna be teaching you how to clean your tank and change your coil. So right here, I have a TFV12 prince tank. Pretty much if you’re gonna clean every tank, it’s almost the same you might have a little bit different moving parts but everything you’re gonna do is the same. Usually what I do is, I just pop all the pieces off, separate the tank and rinse them under hot water. If you want a little bit of this soap doesn’t hurt it and then just rinse it out really good. You’re gonna dry it out.
Now I’m gonna bring you up close and show you exactly what I’m talking about. Up close and personal now I’m gonna show you exactly what I’m talking about especially when cleaning these guys out and exactly how to change your coil. So, like I said I like to take it completely apart. So, I’m gonna pull this drip tip off. Most of them just pull out. I’m gonna open it up. I’m gonna remove the gaskets inside. White gasket there. I’m gonna open the tank up throw my bad coil out. Left with the base, remove the glass from the tank and then I have the top piece which I’m gonna leave open. Usually what I do is I just rinse everything under hot water. I sometimes if it’s really nasty, you got some old juice in there i’ll throw a little bit of dish soap and then just rinse everything out. Then the most important part is that you dry everything very well. So, make sure everything’s really dry after that. Which you’re gonna want to do you’re gonna grab a fresh coil, you’re gonna screw this on. So, this is exactly most tanks are pretty much the same unless you’re using a rebuildable. You just unscrew the old one you screw the new one in. Then I’m gonna start reassembling the tank. I’m gonna take the glass, put that back on. I’m gonna take this top section, put that back on and then I’m gonna put the gasket back on, that in there, close that up. I’m gonna put my drip tip back on. Now this is ready to go.
The only thing I didn’t go over is I didn’t prime the coils. I’m not gonna fill this guy up. But normally when I do this, dry everything off. I would put my coil in. Then prime the coil. Reassemble it like that. Then I would fill the tank up. Let it sit for a little bit.  That’s pretty much how you clean your tank out and change your coil.
Alright guys and that’s basically like I said in the beginning of the video this is the TFV12 prince. If you’re interested in this tank you could find it on our website discountvapepen.com. As always thanks for watching. If you liked what you saw give us a thumbs up, subscribe and check us out at discountvapepen.com.